Owner`s manual

38 MaxMotion for Machines
communication parameters:
9600 baud, 8 data bits, no parity, 1 stop bits, and hardware handshake.
New Hermes EP controller module require generally the following
communication parameters:
9600 baud, 8 data bits, no parity, 1 stop bit, and X-on/X-off handshake.
New Hermes Unica machine require generally the following commu-
nication parameters:
9600 baud, 8 data bits, no parity, 1 stop bit, and hardware handshake.
It is connected to Com 1 or 2 Serial port of your computer.
The controllers for other machines may require different setup.
Set Spool Settings to your liking.
Within the same Properties box, click select Paper. Select Custom
as the paper size and paper source as Continuous - No Page Break.
MaxMotion Identification Adapter
MaxMotion program comes with a special Identification Adapter.
Before invoking MaxMotion, you must first insert the adapter in the
parallel port on your PC computer. Each Identification Adapter is
unique so your MaxMotion program can only execute with the ID
adapter supplied with it. If you wish to attach a printer or a plotter to
the same parallel port, simply plug the parallel cable into the ID
adapter. Once installed, the ID adapter is totally unobtrusive and will
not hinder any of the capabilities of the computer.
The ID adapter has arrows on the side that is connected to the com-
puter. Along with arrows, it has the word computer between the arrows.
This side has a 25 pin male connector. Make sure that this connector
connects to the parallel (printer) port on the PC computer.
Laptop computers may not have the luxury of having more than one
parallel port. In this case, we are offering an ID key that will attach to
the USB port. Make sure you have a laptop computer that is equipped
with a USB port.