Owner`s manual

MaxMotion for Machines Chapter 1-27
Table and Tool Setup
X
Section III
Axis Selection: Normal Cylindrical Automatic Auxillary Controls:
Spindle Motor Left Switch Right Switch Spindle Motor Delay Sec.
Table Setup in Wide in High Start from Start Offsets: X: Y: Z: in Backlash X: Y: Z: Steps
Revert Save Close
Revert Save Close
Acceleration Setup
X
Section IV
Maintain Uniform Speed during output Immediately Stop When limit switch is closed Initial slow movement when jogging steps Reduce tool-speed if Radius below in S Curve Parameters for Speed Ramp
Initial Speed in/sec Acceleration time constant micro seconds Percentage at maximum acceleration percentage