Owner`s manual

MaxMotion for Machines Appendix E-247
four holders and remove them.
F. You will be able to juggle and move the metal plate and the
PC board assembly. Lift the assembly slightly toward the side
of the little monitor. You will find a metal connector to the
side of the PC board with a mating connector attached to it.
These are 44 pin connectors, one female and one male.
G. You connected the position B of the A/B switch box back in
the Step One procedure. Note that there are two cable
assemblies coming out of position A and position Input/
Output. Take the cable assembly coming out of the Input/
Output position. It has two connectors at the other end. One is
a 44 pin connector and will connect to the cable that was
disconnected in step F.
H. The second connector of the Input/Output cable assembly will
replace the connector on the PC board below the metal plate,
(Note a small flat cable connecting one of the small
connectors on the PC board to the small connector on the PC
board on top of the monitor.) the other end of which is on the
PC board on top of the monitor.
J. Now, take a look at the two connectors coming out of the
cable assembly from position A of the A/B Switch box. The 44
pin connector will connect to the side of the PC board under
neath the metal plate. The other small connector will connect
to the mating connector o the PC board on top of the monitor.
K. Guide all the cable assemblies properly. Disconnect the two 25
pin connectors from positions A and Input/Output on the A/B
Switch box. Guide them out of the Wizzard unit in one of the
following two ways:
1. Locate the cooling fan cover in the back of the wizzard
machine toward the side of the monitor. Remove screws and
guide the cable out through the cavity. Replace the screws.
L. Connect the cables back to the A/B switch box in its respective
positions.
M. Attach the A/B switch box to the side of wizzard machine with
the help of velcro.
N. Assemble the wizzard machine back.
P. Always remember to turn the wizzard machine off while
switching the A/B switch box position.
Q. Make sure that the wizzard and the PC/Windows computers
are grounded properly.