Owner`s manual

232 MaxMotion for Machines
H-Square 1912 table - 3 proper amplifiers and one relay
for spindle motor for original motors
Meistergram 912, 1912 - 3 proper amplifiers and one relay
for spindle motor for original motors
Meistergram 1518, 2618 - 3 proper amplifiers and one
relay for spindle motor for original motors
Dahlgren System One - 2 proper amplifiers and one relay
are provided.
Dahlgren System Two - 2 proper amplifiers and one relay
are provided.
Dahlgren System 100 - 500Z - 3 proper amplifiers and one
relay are provided.
Dahlgren System 100 - 500 - 2 proper amplifiers and one
relay are provided.
Dahlgren Wizzard, III, XL, Mark 12 - 3 proper amplifiers
and one relay are provided.
Dahlgren Wizzard PC - Only an A/B switch box is required
to make it work.
Xenetech machine with standard interface - 3 proper
amplifiers and one relay are provided.
P. It is important to note that the electronics is sensitive to static
charge. It is a safe and a good idea to discharge static
electricity, ground the controller and ground yourself before
you touch and work on any electronic components. Static
electricity can ruin electronics.
Q. IT IS ABSOLUTELY ESSENTIAL THAT YOU HAVE A 3
PIN AC OUTLET WITH A TRUE GROUND PIN. THE
FOLLOWING HAS TO BE CONNECTED TO THE
GROUND LINE FOR PROPER OPERATION:
1. THE PC COMPUTER
2. THE MAXAMP UNIT
3. THE MACHINE
4. THE STEP MOTORS IN ADDITION TO THE MACHINE
IF THE STEP MOTORS ARE INSULATED FROM THE
METAL OF THE MACHINE TO REDUCE THE
MECHANICAL NOISE.