Owner`s manual

MaxMotion for Machines Chapter 1-23
processing power makes it possible.
The first check box will guarantee that the machine will move at a
constant linear velocity along all the paths including straight lines,
angular lines, curves, etc.
It would be a good idea to stop the limit switches without decelerating
unless you plan to move to the home position at a very high speed.
Quite often users experience that it is time consuming when the user
tries to position the machine at a specific point for a starting position.
Either you have to jog the machine slowly or you need to go back and
forth to get to the point of choice. MaxMotion allows users to set a
number of steps that may be taken at a slow speed while jogging. This
will make it lot easier and lot less frustrating to position the tool at a
desired position.
The last three values for the set up in this section deals with the S-curve
acceleration and deceleration. Check with the MaxMotion technical
support group for proper settings for this section.
MaxMotion Identification Adapter
MaxMotion program comes with a special Identification Adapter.