Owner`s manual

18 MaxMotion for Machines
user needs to do is to provide the diameter of the object where the
engraving takes place.
Spindle Delay: Spindle delay was always available in MaxMotion
Virtual Controller and it was preset at 1 second in the Initialization file
(MaxMotion.INI). This control of the delay is now brought to the
application interface in order to make it easy for the user to change or
set the delay for values other than 1 second.
Spindle delay activation takes place as follows:
A job is ready to be sent to the machine for engraving or cutting. As
soon as the user clicks "OK" to send the job, MaxMotion checks to see
if the spindle motor is checked in the Section III of the Machine Setup.
If it is, a command is sent to turn the spindle motor on. Next, the
MaxMotion checks for the delay time for the spindle motor in the same
section. MaxMotion will simply wait for the seconds called out in the
delay time before moving the X, Y, and Z axis to proceed to execute the
job. This delay allows the spindle motor to come to the necessary
spindle speed before plunging into the material.
The spindle motor delay time shall be declared in seconds. Please,