Owner`s manual

136 MaxMotion for Machines
calculate the actual line heights. However, this value is a grayed out
when actual values in inches or millimeters are used to define the line
heights. Note that even if the engravable area value cannot be changed
by the operator in this case, it changes constantly as the job design
decisions are taking place. It will give a continuous feed back regarding
the usage of the engravable area. If the number goes over 60 percent
while a job is being designed, it will give an indication that the plate
might be too busy and the job design may not be attractive.
Click CREATE after you have selected all the options. MaxMotion
will calculate all the values and create a layout on the screen. At this
point, MaxMotion is ready for your text entry as well as any graphic
insertions for preparing the job.
However, if you just want to change plate size, margin, default justifi-
cation etc. without creating/reformatting lines, you could do this by
setting lines = 0. Sometimes this is not obvious to user, so next to
‘Create’ we have added ‘Set’ button to do precisely this.
Once the text is entered and the graphics are inserted, the following
changes can be done easily:
1. Add a line at the end of the message or anywhere else in the mes-
sage. Open the Auto Layout dialog box and click CREATE again to
relayout the job. Everything will be recalculated.