Owner`s manual

MaxMotion for Machines Chapter 6-109
3 seconds to process on a 100 MHz Pentium computer before it started
engraving. This is the fastest engraving software on the market.
Normal sequence of engraving is as follows:
The job sorting routines are finely tuned. First the graphics are sorted
with the new sorting to minimize unnecessary travel while up in the air,
then append all text lines at the end. The new sorting of the graphics is
to sort the graphics and logos starting from the shape closest to top left
corner, then the shape nearest to it and so on. Depending upon the
complexity of the graphics, the time to engrave could be cut into half or
more. Text lines are treated as text lines unless they are converted to
paths. If converted to paths, they are treated as graphics and sorted
accordingly. Imported graphics are treated as graphics for sorting
purposes. However, inserted graphics are treated as text lines unless
converted to paths. If it is text, it will go line by line to reduce the travel
time by default. The user can override any default by selecting the
sequences. It will follow and engrave in the order that is selected. If any
part of a job is selected on the screen, the final screen will show the
selected part in blue and the unselected part in black, and it will
engrave the selected part only. Additionally, the Selection Only box
will be automatically checked to notify that a selection was made. The
selection only box can be unselected by checking on the box and
removing the check mark. In this case, the complete job will be
processed.
Normal sequence of routing is as follows:
If it is graphics, the software will sort the job from inside out by
default. If it is text, it will go line by line to reduce the travel time by
default. However, it will rout each character inside out. The user can
override any default by selecting the sequences. It will follow and rout
in the order that is selected. If any part of a job is selected on the
screen, the final screen will show the selected part in blue and the
unselected part in black, and it will rout the selected part only. The
selected shapes will be routed in their respective positions on the job
material.
All settings in the final screen are determined by the material selected
from the material menu. Defaults for each type of material are preset.
Each setting can be changed to suit your requirements. (See Edit
material under material menu). The settings in the final screen will be