Owner`s manual

108 MaxMotion for Machines
■ To setup the zero position for the Z-axis, move the tool up or down
until a desired point is reached. Depress the SURFACE key to inform
the software of your Z position. The Z-axis will move up immediately
by the Z-up value called out in the selected material in the materials
menu.
The system is ready to machine your design needs.
Machine/Plot (Ctrl+T)
Selecting machine/Plot from the File pull down menu will bring up the
machine/plot screen or final screen before sending the file out to the
machine.
Once a command is given to send the job to the engraving machine or
routing machine, the machining will start almost instantaneously. A job
with a graphic and six lines with different fonts in each of the lines took