Owner`s manual

MaxMotion for Machines Chapter 6-107
If the PC/Windows computer used is not Intel 486 DX2/66 MHz or
faster, it may be advisable to turn-off the PAUSE/RESUME capability.
This can be achieved in the Machine setup menu.
Spindle motor enable/disable and Spindle motor delay in millisecond is
set up here.
Control Pad for LapTop Computers:
The Maxmotion software capability is extended with the possibility of
driving the machine from laptop Computers in addition to desktop PC/
Windows computers.
Almost all desktop computer keyboards are designed with 10-key
keypad. Almost all laptop computers do not have space for the keypad.
MaxMotion is now fully functional with laptop computers by adding
the keypad capability on the main keyboard. Such an implementation
was found on Toshiba laptops and was implemented under Maxmotion.
Now, we have two active control pads. One is the 10 key keypad. The
other is as shown on page 7.
Note the following:
■ Control Pad will not work until you bring it up on the screen. Once
the Control Pad is on the screen, do not use the mouse to exercise the
Control Pad. Only the 10-Key keypad of the keyboard will activate the
functions of the Control Pad. While the Control Pad is active, mouse
will not work. Once you are done with the Control Pad, depressing the
ESC key on the keyboard will remove the Pad and the MaxMotion
application will revert back to the main design screen.
■ The software provides acceleration/deceleration capability. If your
driver and motor combination can handle acceleration, you can hold
down one of the directional keys on the Control Pad and depress the
FAST key while continue to hold down the directional key, the
machine will travel faster. The speeds will depend upon the values set
in the materials menu for jog speed and move speed.