Owner`s manual

10 MaxMotion for Machines
Installing the MaxMotion VC (Virtual Controller)
application (PART NUMBER EW-401)
Use the following procedure to install under Windows 3.X
(a) Type or Enter WIN at the DOS prompt to load Windows 3.X, if it is
not loaded already.
(b) Insert the MaxMotion floppy disk into drive a: or b:
(c) From Program Manager, choose Run from the file menu.
Important: If you are using a desktop manager other than Program
Manager, you must run the Program Manager application
PROGRAM.EXE, before executing step c. Running the installer from a
desktop manager other than the Program Manager may produce
unexpected results.
(d) Type a:\setup or b:\setup (depending upon whether the
MaxMotion floppy is inserted in floppy drive A or B) and click OK.
The MaxMotion Installer dialog box appears.
(e) Accept the default target drive and directory displayed in the dialog
box, or select and type a new drive and directory.
(f) Follow the procedures and prompts on the screen and click OK as
prompted.
If MaxMotion was installed previously on the computer, it is possible
that a message might appear for a file named bwcc.dll for it being in
use. Simply, select the option of 'do not install' only for that file. When
installation is completed, a message appears indicating that the installa-
tion was successful.
Use the following procedure to install under Windows 95 and 98
(a) Type or Enter WIN at the DOS prompt to load Windows 95, if it is
not loaded already.