Electronic Keyboard User Manual

ManualsBrandsRoland ManualsElectronic KeyboardATELIER Combo AT-350C

111

112

113

114

115

116

117

118

119

120

118

Troubleshooting

Problems with playback functions

Problem Cause Action Page

Moving your hand over the D Beam

controller does not produce a sound

If a D Beam button is lit in red, moving your hand

above the D Beam controller will apply an eect to

the sound you play from the keyboard.

Press the D Beam button once again so the button

is lit in green.

p. 44

Damper Pedal does not operate

The damper pedal aects only the Lower

keyboard. The damper pedal does not aect the

Upper Keyboards and Bass pedalboard.

This is not a malfunction. - - -

The damper pedal does not aect the Solo voice. This is not a malfunction. - - -

Expression Pedal does not operate

The function of the Expression Pedal during

recording or the function during playback has

been set to “COMPOSER.”

Set the expression pedal function during record-

ing to “PEDAL,” and during playback to “PEDAL” or

“PEDAL+COMPOSER.”

p. 94

Can’t use the function assigned to the foot

switch

If “Registration Shift” (change Registrations)

is “RIGHT,” “LEFT,” or “RIGHT + Load Next,” the

foot switch will be dedicated to switching the

Registration.

Turn “Registration Shift” o. p. 96

Problems with the audio les

Problem Cause Action Page

Can’t play an audio le

Is the audio le in a format supported by the

ATELIER?

To be playable, audio les must be in the following

format.

• File name extension is “.wav”

• 16-bit linear sampling

• Sampling rate is 44.1 kHz

This is not a malfunction. - - -

Can’t record along with an audio le/

Can’t copy an audio le to internal memory

The ATELIER does not allow recording using audio

les, and cannot be used to copy audio les into

internal memory.

This is not a malfunction. - - -