Electronic Keyboard User Manual

Before You Start Playing

The confirmation message appears on screen.

fig.00-40-1.eps

If you touch <Cancel>, the Factory Reset will not be

performed, and you will return to the System screen.

When you touch <OK>, the Factory Reset

operation will begin, and the settings will

return to the factory-set condition.

Never switch off the power while this operation is in

progress!

fig.00-40-2.eps

Loading factory default settings will erase any Registrations

currently in the memory of the ATELIER. To save the

registrations you are currently using, refer to “Saving

Registration Sets” (p. 113).

If you want to restore settings other than those for User

Memory (p. 82) to the factory-set condition, touch <Panel

Reset> in the System Utility screen. If you want to restore

only the user memory to the factory-set condition, refer to

page 230.

NOTE

You can also use the following method to return to the

factory-set condition.

Method 1

1. Touch <Quick Guide> on the Main screen,

to display the Quick Guide screen.

2. Press the [One Touch Program] button.

The confirmation message appears on screen.

fig.00-40-1.eps

If you touch <Cancel>, the Factory Reset will not be

performed, and you will return to the System screen.

3. When you touch <OK>, the Factory Reset

operation will begin, and the settings will

return to the factory-set condition.

Method 2

1. Turn down the volume to the minimum

level, then turn off the power.

2. While holding down the [One Touch

Program] button, press the [Power On]

switch to turn the power on.

fig.00-41.eps

The following screen appears.

fig.00-40-3.eps

AT-900_e.book 28 ページ２００７年９月７日　金曜日　午前８時４３分