Owner`s manual

AR-200S RS-232C Reference -

= TQ Time Stamp Request

Function1: Time Stamp request

Syntax: stxTQ: a;

a Phrase number

Note: Output the recording start time information for the specified phrase. (Refer to

4.4.1 TI Command.) The AR-200S outputs an ER command for phrases in which

time information is not recorded.

Function2: Time Stamp request

If the phrase number is not specified as a parameter, the AR-200S will output the

Time Stamp information for automatically incremented phrase number by the

Phrase Output Counter.

Syntax: stxTQ:;

Note: The incremented value will skip phrase numbers which are not recorded yet, and

will be up to the next recorded phrase number. If the TQ command is used to

request output even after the setting information of the last phrase has been

output, the AR-200S will output “stx ER:101;”.

= UQ Program (Count) Playback Setting Contents Request

Function: Program (Count) Playback setting contents request

Syntax: stxUQ: a, b;

a Reserved (0)

b Program Playback patterns(1 - 5)

Note: refer to CE command

= VR Version Request

Function: Version request

Syntax: stxVR;

Note: The AR-200S will output the “model name” and “version”.

(* refer to the 4.4.1 VR command for the AR-200S)

4.2.5 Reply Commands

= ACK Response to Normal Reception of a Command

Function: Response to normal reception of a command

Syntax: ACK (06H)

= ER Reply to the AR-200S When an Error Has Occurred

Function: Reply to the AR-200S when an error has occurred

Syntax: stxER: a;

a Error number

0 Send this command to the AR-200S when the output of the AR-200S could not

be read (In the case of a request command, the AR-200S will re-transmit

the Setting output command.)

1 Send this command when the output of the AR-200S for confirmation is

incorrect in Delete mode. Then the command you transmitted will be canceled,

and the AR-200S will automatically exit Delete mode.