Owner`s manual

AR-200S RS-232C Reference -

> QQ Phrase Setting Contents Request

Function1: Phrase setting contents request

Syntax: stxQQ: a;

a Phrase number

Note: The phrase settings for the specified phrase number will be output.

The value of the Phrase Output Counter (described below) will not change.

(* refer to the RU command)

Function2: If the phrase number is not specified as a parameter, the AR-200S will output the

phrase settings for automatically incremented phrase number by the Phrase Output

Counter.

Syntax: stxQQ:;

Note: The incremented value will skip phrase numbers which are not recorded yet, and

will be up to the next recorded phrase number. If the PQ command is used to

request output even after the setting information of the last phrase has been

output, the AR-200S will output “stx ER:101;”.

In the case of a Pattern Phrase, you must use the separately described 3Q

command to request output of the settings. (* refer to 3Q command)

* About the Phrase Output Counter

The AR-200S contains the Phrase Output Counter. The maximum value of this

counter is the maximum phrase number of each card. The counter is reset (i.e.,

to the lowest phrase number) by the AQ command. So you can request each

phrase settings of all phrases in the card by sequentially using the QQ

command’s function 2 after resetting the counter.

< SQ System Setting Contents Request

Function: System setting contents request

Syntax: stxSQ: a;

a Reserved (0)

Note: refer to SM command

> YQ System Setting Contents Request

Function: System setting contents request

Syntax: stxYQ: a;

a Reserved (0)

Note: refer to SY command