Owner`s manual

AR-200S RS-232C Reference -

4.2.4 Request Commands

< 2Q Pattern Phrase Setting Contents Request

Function: Pattern Phrase setting contents request

Syntax: stx2Q: a;

a Pattern Phrase number

Note: This is a request for when the phrase type is pattern phrase.

(* refer to PU command)

> 3Q Pattern Phrase Setting Contents Request

Function: Pattern Phrase setting contents request

Syntax: stx3Q: a;

a Pattern Phrase number

Note: This is a request for when the phrase type is pattern phrase.

(* refer to PS command)

> GQ Song Phrase Setting Contents Request

Function: Song Phrase setting contents request

Syntax: stxGQ: a;

a Song Phrase number

Note: This is a request for when the phrase type is song phrase.

(* refer to SS command)

= AC Activity Sensing (Verify AR-200S Unit Activity)

Function: Activity sensing (Verify AR-200S unit activity)

Syntax: stxAC;

Note: Normally, an ACK command will be output from the AR-200S by using this

command.

During recording , playback or playpause, the Phrase number will be output.

= AQ Reset the Phrase Output Counter

Function: Reset the Phrase Output Counter

Syntax: stxAQ: a;

a Reserved (0)

Note: This sets the Phrase Output Counter to the lowest-numbered phrase of the

phrases registered in the card. Use this command before you wish to output the

settings of all phrases by using the PQ command, for example when you confirm

the initial settings.

= CQ Card Setting Contents Request

Function: Card setting contents request

Syntax: stxCQ: a;

a Reserved (0)

Note: refer to CS command