Owner`s manual

R
AR-200S RS-232C Reference - 14
4.2.2 Editing Commands
= DM Enable Execution of Editing Commands
Function: Enable execution of editing commands.
Syntax: stxDM;
Note: In order for editing commands to be executed, the DM command must be used to
put the unit into Delete mode. For the communication protocol, refer to 4.1 2)
Editing commands.
Caution: When Delete mode is exited, the AR-200S will automatically output a CC command.
The AR-200S automatically escapes from the Delete mode two minutes after the
DM command is issued. To run editing commands, send a DM command again to
enter the Delete mode.
Card Editing
= CD Delete Card
Function: Delete Card
Syntax: stxDM;
stxCD: a;
a Reserved (0)
Example) CD:0;
Erase all phrases from a PC card.
= FM Format Card
Function: Format Card
Syntax: stxDM;
stxFM: a , b , c;
a Reserved (0)
b Maximum number of phrase
0 250
1 500
2 1000
c Reserved ( 0 or 1 )
Example) FM:0,1,0;
The card is formatted as follows; the maximum number of phrases “500”.
Note: The type and capacity of the card is detected automatically.
Use only cards which the AR-200S is able to use.
= LS Recorded Phrase Protect Mode
Function: Recorded phrase protect mode
Syntax: stxDM;
stxLS: a;
a Select ON/OFF
0 OFF
1 ON
> LW Recorded Phrase Protect Mode
Function: Recorded phrase protect mode
Syntax: stxDM;
stxLW: a, b;
a Reserved (0)
b Select ON/OFF
0 OFF
1 ON