Owner`s manual

R
AR-200S RS-232C Reference - 10
Note: The number of digits for **F (frame) increases according to the value of MTC
type.
The range in which the offset time can be specified is valid only within a single
phrase.
An offset time that exceeds the recording time for the phrase cannot be
specified.
(The AR-200S outputs an ER command.) You can play back a phrase from a
point offset by a specified time before or after a paused point by sending this
command while playback is paused (see the PE command).
* When “Return Specified” is issued with an offset time longer than elapsed time:
The phrase is played back from the beginning.
* When “Forward Specified” is issued with an offset time longer than the
remaining time: An ER command is output and playback is not carried out. (The
paused state remains in effect, so specify a new offset time and send an RL
command again.)
Caution: The command is not compatible with the Dual Mono Mode.
Phrases other than audio phrases cannot be specified.
The command is not compatible with audio phrases recorded in Mode 2.
>PLL Start Left Channel Playback (Dual Mono Mode)
Function: Starts playback of the left channel
Syntax: stxPLL;
Example) stxPA:A0001,A0003,A0007,A0006,A0010;
When Dual Mono Mode is on and the above phrases are specified with the PA command,
phrases A0001, A0003, and A0007 are played back in sequence through the left
channel.
Note: Odd-numbered phrases specified with the PA command are played back in sequence
through the left channel.
If no playback phrase is specified with the PA command, phrase A0001 is assigned and
played back.(* If no phrases are available, the ER command is output.)
Compatible with mono phrases. Not compatible with stereo phrases. For more details,
refer to the AR-200S Owner's Manual.
Caution: If the AR-200S is not set to Dual Mono Mode, the ER command is output.
Interval playback does not go into effect, even if the playback mode is set to interval
playback with the AR-200S.