User`s manual

4-6 Changing How the Printer Operates
Chapter 4 Feature Reference
94
Changing the Menu Language and the Units of Measurement
Procedure
➊
Hold down and switch on the sub power.
Use
to select the display (menu) language.
Press
.
➋
Use to select the measurement unit for length.
Press
.
➌
Use to select to the measurement unit for tempera-
ture.
Press
.
Description
This sets the language and units of measurement displayed on the printer's screen.
Default Setting
[MENU LANGUAGE]: ENGLISH
[LENGTH UNIT]: mm
[TEMP. UNIT]: ˚C
Drying the Trailing Edge of the Printing Area on the Dryer
Procedure
➊
Hold down and press .
➋
Press .
Use
to select "ENABLE."
Press
to enable the setting.
➌
Press .
Press
to go back to the original screen.
Description
When this menu item is set to "ENABLE," additional media feed is performed until the trailing edge of the printing area
is positioned directly on the dryer. The margin between the print-end position and the next print-start position is fixed
at 200 mm. Any margin setting made on the computer is ignored.
When this is set to "DISABLE," media feed stops simultaneously when printing ends. This means that the trailing edge
of the printing area is not fed to the dryer unless you continue with a subsequent printing operation.
Default Setting
[FEED FOR DRY]: DISABLE
W 2600 mm
SETUP SHEET
HEATER MENU
FEED FOR DRY
FEED FOR DRY
DISABLE
ENABLE
MENU LANGUAGE
ENGLISH
LENGTH UNIT
mm
mm
TEMP. UNIT
C
C