User`s manual

82
Chapter 4 Feature Reference
4-4 Optimizing Printing to Match Media Thickness
Adjusting Head Height to Match Media Thickness
Procedure
➊
Press .
Press
several times.
➋
Press .
Use
to make the setting for the height.
Press
to enable the setting.
➌
Press .
Press
to go back to the original screen.
Description
Depending on the media, media may wrinkle or come loose from the platen during printing, increasing the chance of
contact with the print heads. When you are using such media, adjust the head height to "HIGH."
Note that the height of the heads cannot be determined by just the thickness of the media.
When the height is set to "LOW," the media clamps cannot be used. Except in special cases, the "LOW" setting
should never be used. Doing so may cause the heads to strike the clamps and become damaged.
Default Setting
[HEAD HEIGHT]: MIDDLE
W 2600 mm
SETUP SHEET
MENU
HEAD HEIGHT
HEAD HEIGHT
MIDDLE
HIGH