User`s manual

2-2 Loading and Cutting Off Media
34
Chapter 2 Operation
1. Mount the media and the paper pipe on the roll shaft.
➊
Load the media onto the roll shaft.
Press in to fit on securely. Press in to fit on securely.
End cap
Hexagonal
wrench (large)
Roll media
Be careful to orient correctly when loading.
Reinforcement pipe
(for media having a width of
1,800 mm [74 inch] or more)
End cap
Align the distance between the bearing and the edge
of the media.
* The media gauge has a scale indicating media width.
Place the end of the media gauge against the edge of the
media and align the end face of the bearing with the
scale mark for the media width you're using.
■ Media having an outward curl
■ Media having an outward curl
Hexagonal
wrench (large)
Printed surface
Printed surface
For a media width of 2,500 mm
Spacer
Roll shaft
Media gauge
Bearing
Bearing
Place this surface against
the media.