User`s manual

ManualsBrandsRoland ManualsComputer equipmentAJ-1000

101

102

103

104

105

106

107

108

109

110

108

Chapter 5 What to Do If

The Printer Unit Doesn't Run

Is the power switched on?

Switch on the printer's main power, then press the sub power

switch and make sure the sub power switch lights up.

Is illuminated?

Printing is not performed when is not illuminated.

Pull back the loading lever, close the front cover, and

press

Is the front cover open?

Close the front cover.

Is the top menu displayed?

If the top menu isn't displayed, print-

ing doesn't start even when data is

sent from the computer. To go to the

top menu, press

, then press .

Is illuminated?

When lights up, operation is paused. To resume,

press

. goes dark and printing resumes.

Has ink run out?

If a warning beep sounds and the

screen shown in the figure appears,

the ink cartridge indicated by the flashing number is empty.

Replace it with a new ink cartridge.

At the [EMPTY MODE] menu, you can make the setting

that determines whether printing starts when the printer

receives printing data while an ink cartridge is empty.

☞ p 92 "Determining What Happens When an Ink Car-

tridge Is Empty"

Is a message displayed on the screen?

☞ p 115 "If a Message Appears"

☞ p 116 "If an Error Message Appears"

Is the cable connected?

Connect the cable securely.

The Media Take-up or Feed System Doesn't Run

Is the power switched on?

Switch on both the printer's main power switch and the

power switch for the take-up and feed units. To perform

take-up and feed automatically during printing, also make

the setting for the AUTO switch.

Is the cover closed securely?

The take-up and feed units do not operate unless the cover

is securely closed.

5-1 The Machine Doesn't Run

Is media loaded correctly?

Make sure the media is passed through the guide roller and

dancer rollers correctly.

The Dryer Doesn't Warm Up

Is the main power switch for the dryer turned on?

Turn on the main power switch for the dryer.

Is the dryer's power cord connected?

Connect the power cord securely.

Is media loaded?

The dryer does not warm up to the preset temperature

when

is dark (unless the default setting has been

changed). Load media, press

, and wait for the ma-

chine to warm up.

☞ p 96 "Determining How the Media Heating System

Operates"

Is the temperature of the room too low?

Use the machine in an environment where the temperature

is 20 to 32˚C (68 to 90˚F).

Is the power supply the right voltage?

This machine requires 200 to 240 V power. Please note that

it will not operate correctly at a lower voltage.

The Preheater and Print Heater Don't Warm Up

Is media loaded?

The preheater and print heater do not warm up to the pre-

set temperature when

is dark (unless the default set-

ting has been changed). Load media, press

, and

wait for the machine to warm up.