Owner`s manual

9
VM-C7200/C7100 Newly Added Functions
3. Press [AUTO-MIX] under CH STATUS.
4. Press the status buttons for the channel for which auto-
mixing is to be recorded to set it to the recording state
(indicator: red).
5. Press [PAGE UP] or [PAGE DOWN] to display
“DELAY/DN” page.
6. Press [PLAY] to start recording auto-mixing. Every time
[F1] is pressed, dynamics processor switches on/off
alternately and the status is recorded in the auto-mix.
7. Press [STOP] to stop recording.
Editing On/Off switch setting of the dynamics
processors
To edit On/Off switch setting of the dynamics processors,
open “AUTO MIX EDIT” page (Owner’s Manual p.208), then
set “COMP SW” or “EXP SW” to be displayed with V2 knob
(PARAM).
Others
Effects Bypass Switch
Effects bypass switch is added in “EDIT” pages for Effects 1–
8 and Master Effects, to temporarily switch on/off the effect.
1. Press [EFFECTS1-8] or [SP MODELING(MASTER FX)].
2. Press [EDIT] of desired effect.
fig.08_70
3. Effect on/off switches every time [F6] (BYPASS) is
pressed. When “BYPASS” at the bottom right in the
display is highlighted, the signal is bypassed (effect is
temporarily turned off).
* Bypass switch cannot be stored in the scene. It will be cleared
when recalling the scene.
INPLACE SOLO
Function is modified when SOLO MODE (Owner’s Manual
p.107) is set to INPLACE as follows. When soloing INPUT or
MULTI IN, the effect inserted to FLEX BUS can be monitored
simultaneously. If SOLO mode is not “INPLACE,” function
is the same as the previous version.
1. When [SOLO] for INPUT or MULTI IN is pressed, only
INPUT and MULTI IN channels which are not soloed are
muted. (With the version 1.11 or before, Flex Buses are
also muted in this case.)
2. Flex Buses cannot be soloed. (With the version 1.11 or
before, Flex Busses can be soloed.)
SOLO SW Flashing
Any channel of INPUT or MULTI IN is soloed, SOLO
indicator of CH STATUS flashes to show SOLO is on.
Monitor Source Select
Frequently assigned sources for the monitor are available on
[F2] – [F5] for quick setting.
1. Press [SOURCE SELECT].
fig.09_70
2. Select a desired source among the following switches.
[F2] (DIG IN) Input ch21/22 (DIGITAL IN is routed
as a default.)
[F3] (CONSOL) Input ch23/24 (CONSOLE IN is routed
as a default.)
[F4] (MAIN) MAIN OUT
[F5] (CUE) CUE OUT
*
[F2] switch always monitors the sources assigned to the input
ch21/22 and [F3] monitors the sources assigned ch23/24. If
you change the preset routing (DIGITAL IN to ch21/22 and
CONSOLE IN to ch23/24) with PATCH BAY, currently
assigned sources are monitored.