Owner`s manual

8
VM-C7200/C7100 Newly Added Functions
Expander
Expanding the dynamic range with a certain ratio.
fig.05_70
[ON] On/Off switch of the expander
Thresh Threshold level at which the expander starts
working.
Ratio Expanding ratio to the input signal level
Attack Time how quickly the expander starts working
when the input signal exceeds the threshold
level.
Release Time how long the expander works after the
input signal has fallen below the threshold
level.
Detect Time Delay time of the input signal into the
expander. For more strict dynamics control.
Limiter
Same editing parameters as Compressor except Ratio is
preset to INF.
Gate
Same editing parameters as EXPANDER except Ratio is
preset to INF.
Using Libraries
Libraries are available for the dynamics processors as well as
the existing Delay and EQ libraries (**). To use the Dynamics
Libraries, press [COPY/LIBRARY] in “DELAY/DY” page.
* Dynamics libraries are shared by Compressor and Expander
algorithms. Patch names of the algorithms which are not
currently selected are displayed with < >, and cannot be
loaded. In the user area of the libraries, you can overwrite and
save the current algorithm setting even on these < > patches.
fig.06_70
Scene
Dynamics processors can be stored in the scene. Following
steps are to recall the dynamics processor setting with the
scene.
fig.07_70
1. Hold down [SHIFT], and press [SCENE].
2. Press [CURSOR UP] or [CUTSOR DOWN] to move the
cursor to the top row of ACTIVE PARAMETERS.
3. Press [F4] (DYNAMIC) to highlight “DYNAMIC.”
4. Press [LEVEL METER].
Automix
On/Off switch setting of the dynamics processors can be
stored with Automix. Please also refer to “Chapter 11
Recording/Playing Back Fader or Knob Actions (Automix)”
(Owner’s Manual p. 196–).
Recording On/Off switch setting of the
dynamics processors
1. Press any of the buttons in SECTION to select one of the
sections.
2. Press [AUTO-MIX] (indicator: red).