Owner`s manual

7
VM-C7200/C7100 Newly Added Functions
fig.03_70
4. Highlight the desired algorithm with V1 knob
(SELECT).
5. Press [F1] (SET) to make the algorithm effective on the
channel. Dialog is closed and the edit page of the selected
algorithm appears.
* If
[F2] (ALL SET) is pressed instead of [F1 (SET)] , same
selected algorithm is assigned to every channel.
Dynamics algorithm can also be selected as follows.
1. Press [CH EDIT] of the channel you wish to use the
dynamics processor.
2. Press [PAGE UP], [PAGE DOWN] to display
“DELAY/DY” page.
fig.03_70
3. Press CURSOR [UP], [DOWN] to move the cursor to the
top-center in the display.
4. Press [F6] (DLY/DYN). SELECT ALGORITHM dialog
appears.
5. Highlight the desired algorithm with V1 knob
(SELECT).
6. Press [F1] (SET) to make the algorithm effective on the
channel. Dialog is closed and the edit page of the selected
algorithm appears.
Editing Dynamics Processor
By the dynamics algorithm you selected, contents of the edit
page in “DELAY/DY” vary.
Compressor
Compresses the total output signal when the input level
surpasses the threshold.
fig.04_70
[ON] On/Off switch of the compressor
Level Output signal level of the compressor
Thresh Level at which the compressor starts working.
Ratio Compression ratio to the input signal level
[AutoGain] When on, total output level of the compressor
is automatically regulated.
Attack Time how quickly the compressor starts
working when the input signal exceeds the
threshold level.
Release Time how long the compressor works after the
input signal has fallen below the threshold
level.
Detect Time Delay time of the input signal into the
compressor. For more strict dynamics control.