Owner`s manual
6
VM-C7200/C7100 Newly Added Functions
* Latest song list can be displayed by pressing
[F6] (SCAN)
.
Song Store
You can store the current song to the VSR-880 hard disk.
1. Hold down [SHIFT], and press [SYSTEM (PROJECT).
The SYSTEM menu appears in the display.
2. Select “SYSTEM CONFIG” and then “R-BUS (1/2/3)”
page.
3. Press [F3] (STORE) and Song Store is executed.
Shutdown
You can shut down the VSR-880.
1. Hold down [SHIFT], and press [SYSTEM (PROJECT).
The SYSTEM menu appears in the display.
2. Select “SYSTEM CONFIG” and then “R-BUS (1/2/3)”
page.
3. Press [F4] (SHUT) and Shutdown is executed.
Scrub Playback
1. Hold down [SHIFT], and press [PLAY]. The VSR-880
turns into scrub playback mode. Following dialogue
appears.
fig.vsr2_70
2. Press [CH STATUS] of desired channel for scrub
preview.
3. Turn the TIME/VALUE dial to scrub.
4. Press [F6] (EXIT) to stop scrub playback.
* In the Scrub playback mode, you cannot switch the display
page.
Newly Added Functions (Ver.1.5)
Following functions have been added to the system for the
VM-C7200/C7100 (V-Mixing Console; Ver.1.5 or later).
When you turn on the power of the VM-C7200/7100, current
system version number of your VM-C7200/C7100 will be
appeared in the display.
Dynamics Processing on Every
Input Channel
With the VM-7000 Ver.1.5, one of the following dynamics
processor is available individually on every INPUT and
MULTI IN channel.
• Compressor
• Expander
• Limiter (Compressor with RATIO:INF)
• Gate (Expander with RATIO:INF)
* These dynamics processors are achieved by sharing the
algorithm resources with the Feedback Delay (Owner’s
Manual p. 81) and the Equalizer (Owner’s Manual p. 78) on
the channel. You cannot use the Feedback Delay and LO-MID
Equalizer on the channel which the dynamics processor is on.
Selecting the dynamics processor
Select a desired dynamics processing algorithm on the
channel as follows.
1. Press [CH EDIT] of the channel you wish to use the
dynamics processor.
2. Press [PAGE UP], [PAGE DOWN] to display
“DELAY/DY” page.
fig.01_70
3. Press [F5] (ALGORITHM DLY/DYN). SELECT
ALGORITHM dialog appears.