Owner`s manual

5
VM-C7200/C7100 Newly Added Functions
VSR-880 Settings
Set the some parameters of the VSR-880 as follows.
MASTER Direct Out: On
INPUT MIXER IN1 Input: R-BUS
IN2 Input: R-BUS
IN3 Input: R-BUS
IN4 Input: R-BUS
IN5 Input: R-BUS
IN6 Input: R-BUS
IN7 Input: R-BUS
IN8 Input: R-BUS
SYSTEM:System PRM MasterClk: R-BUS
SYSTEM:MIDI PRM MIDIThr: Out (1st unit),
Thru (2nd unit)
SysEx.Rx: On
SysEx.Tx: On (1st unit)
MMC: MASTER (1st unit),
SLAVE (2nd & 3rd units)
SYSTEM:Sync/Tempo Sync Source: EXT
InSel: R-BUS (1st unit),
MIDI (2nd & 3rd units)
Gen.: MTC (1st unit)
MTC Type: 30
* Refer to the VSR-880 Owner’s Manual p. 140 “Synchronized
operation of two or more VSR-880 units.”
VM-7000 settings
Set the master clock of the VM-7200/7100 to “INTERNAL” as
follows.
1. Hold down [SHIFT], and press [SYSTEM] (PROJECT).
The SYSTEM menu appears in the display.
2. Press [DOWN] cursor, then press [F1] (DIGITAL I/O).
3. Set up the following in the SETUP page.
WORD CLOCK SOURCE:...........................................INTERNAL
INTERNAL SAMPLING RATE:
.........in accordance with the sampling rate of the VSR-880 song
4. Press [LEVEL METER] to return to initial display.
* Refer to the VM-C7200/C7100 Owner’s Manual p. 32
“Checking the overall system.”
Also, set the SYNC MASTER settings of the VM-7200/7100
as follows.
1. Hold down [SHIFT], and press [SYSTEM] (PROJECT).
The SYSTEM menu appears in the display.
2. Press [DOWN] cursor, then press [F3] (SYNC CLOCK).
3. Set up the following in the SETUP page.
SYNC MASTER: INT
MMC CONTROL: ON
MMC MASTER: INT
MACHINE TYPE: HD
4. Press [LEVEL METER] to return to initial display.
MTR control functions
If the VSR-880 is connected to the VM-7100/7200 via R-BUS,
following functions are supported, in addition to the existing
MTR control functions such as transport, locator and channel
status.
• Song Select
• Song Store
• Shutdown
• Scrub playback
Song Select
You can select a song from the VSR-880 hard disk.
1. Hold down [SHIFT], and press [SYSTEM] (PROJECT).
The SYSTEM menu appears in the display.
2. Select “SYSTEM CONFIG” and then “R-BUS (1/2/3)”
page.
3. Following appears in the display.
fig.vsr1_70
4. List of the songs in the VSR-880 hard disk appears.
5. Highlight a desired song with V1 knob (SELECT
SONG).
6. Press [F1] (SELECT) and Song Select is executed.
* If multiple VSR-880 are connected to the R-BUS 1/2/3, a song
of the same number in each VSR-880 can be selected at once by
pressing
[F2] (SELECT ALL) . It is convenient when you
construct 16-track system with two VSR-880, or 24-track
system with three VSR-880.