Owner's manual

Connecting the A-49 to an iPad
2
Using the A-49 with a Computer
If you want to use the A-49 while it’s connected to a computer after having previously connected it to an iPad, you must switch the USB driver used by
the A-49 to “ADVANCED.”
1 3
2
1. While holding down the [S1] button and [S2] button, connect the A-49 to the computer.
Once the A-49’s power has turned on, release the [S1] button and [S2] button.
2. Press the [FUNCTION] button " [ADV] key (keyboard) " [+] button, in that order.
3. Disconnect the USB cable from the A-49, and then reconnect it.
MEMO
• If you’re connecting the A-49 to a computer in which the USB driver has not been installed, disconnect the USB cable from the A-49, and install the
USB driver in the computer as described in the section “Installing the Driver” in the owner’s manual for the A-49.
• It will not be necessary to switch the USB driver the next time you connect the A-49 to the computer. Simply connect the A-49 to the computer
and it will be ready for use.
Copyright © 2012 ROLAND CORPORATION
All rights reserved. No part of this publication may be reproduced in any form without the written permission of ROLAND CORPORATION.
Company names and product names appearing in this document are registered trademarks or trademarks of their respective owners.