User Manual
30
Other Features
Returning Settings to the Factory-
default State (Factory Reset)
You can return the values of settings on the V-1SDI to
their factory defaults.
If operation that diers from what is described in
the Owner’s Manual occurs even when the steps
described are followed correctly, try performing a
factory reset.
NOTE
5 Performing a factory reset causes all settings made and
values saved in memory (p. 13) to be lost.
1. Display the SETUP menu (p. 12), then select
“FACTORY RESET.”
2. Move the A/B fader to the bus A position.
3. Make sure the message “PRESS “UP”” is
displayed, and press the [DSK] (
) button.
(If you want to cancel the operation, move the
A/B fader to the bus B position or press the
[AUTO] (
) button.)
A factory reset is executed.
4. Quit the menu (p. 12).
Preventing Unintended
Operation (Panel Lock)
This locks operation of buttons and knobs to prevent
unintended operation of the V-1SDI.
1. Display the SETUP menu (p. 12), then select the
targets for panel lock.
You can select the following menu items as
targets for panel lock.
PANEL LOCK (page 10/16)
Menu item Target of panel lock
ALL SW & VOLUME
All controls listed at the PANEL
LOCK menu item
RIGHT SW
The following buttons on the
right side of the panel
DSK SW [DSK] button
AUTO SW [AUTO] button
LEFT SW
The following buttons on the left
side of the panel
FREEZE SW [FREEZE] button
MEMORY SW [MEMORY] button
AUDIO SW [AUDIO] button
PANEL LOCK (page 11/16)
CENTER SW
The following buttons at the
center of the panel
A/B BUS SW
[A-1]–[A-4] buttons
[B-1]–[B-4] buttons
KEY LEVEL SW [KEY LEVEL] button
WIPE SW [WIPE] button
MIX SW [MIX] button
CUT SW [CUT] button
PinP SW [PinP] button
SPLIT SW [SPLIT] button
PANEL LOCK (page 12/16)
VOLUME
The following knobs and the
A/B fader
OUTPUT FADE VOL [OUTPUT FADE] knob
CONTROL 1 VOL [CONTROL 1] knob
CONTROL 2 VOL [CONTROL 2] knob
A/B FADER A/B fader
2. Use the A/B fader to set panel lock to enabled
(ON) or disabled (OFF).
3. Quit the menu (p. 12).
The SETUP indicator lights up when an attempt is
made to operate a button, knob, or other control
for which panel lock is enabled.