User Manual

13
Basic Operation
Saving/Recalling Settings (Memory)
You can take the current settings, including video and audio settings and the state of the operation panel, and save
them as a single set in memory, for later recall and use when needed. The V-1SDI is provided with eight memories.
Settings Saved in Memory
The following menu settings and operation-panel
states are saved in the memories (1 through 8).
SETUP Menu Settings (Some)
The settings from VIDEO INPUT (page 1/16) to DSK
(page 8/16) are saved.
AUDIO Menu Settings (All)
State of the Operation Panel
State of the [OUTPUT FADE] knob
State of the [CONTROL 1] and [CONTROL 2] knobs
On/o status of the [PinP] and [SPLIT] buttons
[A-1] through [A-4] button selection
[B-1] through [B-4] button selection
On/o status of the [KEY LEVEL] button
[MIX], [WIPE], and [CUT] button selection
On/o status of the [DSK] button
State of the A/B fader
MEMO
5 The SETUP menu settings from PANEL (page 9/16)
through SYSTEM (page 16/16) are not saved in memory.
Only a single set is saved in the unit.
After settings have been changed, they are saved in the
unit when you exit the menu.
5 You can recall settings at a specied memory number
at startup. To specify the memory number you want
to recall, go to the SETUP menu, and at MEMORY
(page 13/16), use “POWER ON LOAD.”
5 By factory default, the state of the operation panel is
updated to the state saved in memory when you recall
a memory.
To keep the state of the operation panel from being
updated, go to the SETUP menu, and at MEMORY
(page 13/16), set “MEMORY PANEL LOAD” to “OFF.”
Saving/Recalling
The memory function is turned on while the
[MEMORY] button is held depressed.
At this time the [A-1] through [A-4] and [B-1] through
[B-4] buttons function as memory selection buttons
1 through 8.
The currently selected button lights up in blue.
Memory number
1–4
5–8
Memory 1 functions as a Last Memory.
By factory default, memory 1 functions as a Last Memory.
Settings are automatically saved in memory 1 when you
exit the menu or release the [MEMORY] button.
To stop using the Last Memory function, go to the SETUP
menu, and at MEMORY (page 13/16), set “AUTO MEMORY”
to “OFF.”
Saving
NOTE
5 When memory 1 has been selected as a destination for
saving, the values saved there might be overwritten by
the Last Memory function.
1. Hold down the [MEMORY] button and press and
hold (for 2 seconds or longer) the button from
[A-1] though [A-4] and [B-1] through [B-4] for the
number where you want to save the settings.
The [A-1] through [A-4] and [B-1] through [B-4]
buttons all briey light up in blue, and the
current settings are saved.
2. To turn o the memory function, release the
[MEMORY] button.
Recalling
1. Hold down the [MEMORY] button and press
the button from [A-1] though [A-4] and [B-1]
through [B-4] for the number where you want to
recall the settings.
The settings are recalled. The currently selected
button lights up in blue.
2. To turn o the memory function, release the
[MEMORY] button.