User Manual

15
Part Names and Functions
7. SCALING Section
Use the controls in this section to zoom the screen in/out or adjust the display position. When you are applying Picture-in-Picture,
use the controls in this section to adjust the size and display position of the inset screen.
8. TRANSITION Dial and Indicator
Use this dial to set the transition time.
* By default, the unit displays the transition time in seconds.. Use the menus (p. 48) to select a dierent unit (frames or seconds + frames).
9. Input Selectors
This has 5 buttons each in the A-BUS/PGM and B-BUS/PST sections. Use these to select the output video and standby video.
A-BUS/PGM
When you are making a selection while in the PGM/PST mode (p. 28), the button for the current output channel lights up red.
When you are making a selection while in the A/B mode (p. 31), these choose the channel for A-Bus.
B-BUS/PST
When you are making a selection while in the PGM/PST mode, these choose the channel you want to output next (standby).
When you are making a selection while in the A/B mode, these choose the channel for B-Bus.
Use the HDMI, RGB/COMPONENT, and COMPOSITE buttons to assign sources to each channel (p. 19). The lighted color and dark
state of these buttons are switched as described below.
Red This is the default. In this mode, assign a source after pressing a button (1 to 4) in the bus of current output.
Green In this mode, assign a source after pressing a button (1 to 4) in the bus of standby.
Orange The button lights up orange when sharing a source (p. 21).
Unlighted In this mode, sources cannot be assigned using the HDMI, RGB/COMPONENT, and COMPOSITE buttons.
The [INPUT STATUS] indicators light up when the assignment and the input match. They do not light up when the assignment and
input are dierent.
10. PinP Selectors
Pressing one of the buttons from 1 to 4 applies picture-in-picture.
11. WIPE PATTERN Selectors
These select a transition eect.
* Use the menus to assign other wipe patterns to the WIPE 1 and 2 buttons.
12. AUTO Button
Pressing this button outputs the standby channel. Pressing this button applies the eect selected using the [WIPE PATTERN]
buttons, for the time set using the [TRANSITION] dial.
13. Video Fader
Use this to apply a transition manually. When the transition is made manually, the time for the transition eect changes depending
on the movement of the video fader, regardless of the setting made using the [TRANSITION] dial.
14. SETUP Section
Use this when displaying the menu screen to change settings on the V-40HD (p. 45).
15. DSK Sec tion
When performing DSK composition, pressing the [AUTO] button in this section to make the DSK source (foreground video) appear
or disappear. Also adjust the amount of keying by turning the [KEY LEVEL] dial (p. 35).
* By default, the setting is to apply black extraction. Use the menus (p. 49) to change the settings.