User manual

30 WisDom User Manual
3)
Enter your 2 digit remote access code within 10 seconds. If
you wait longer than 10 seconds the system automatically
switches to MODEM mode. The sound of the connected
modem is heard, and the call must be made again, as
described in step 1.
4)
Once you have entered the remote access code the following
message is announced:
” Hello, Please Enter Your User Code, Followed By [#] ”.
5)
Enter the user code you usually enter in the WisDom
followed by [# ].
NOTE:
If an invalid user code is entered the “Wrong Code” message will be heard.
If a valid user code is not entered within 10 seconds, the system hangs up,
and the call must be made again, as described in step 1.
If 3 invalid user codes are entered within 10 minutes, the system hangs up
and is then locked for 15 minutes. During this time, any calls initiated to the
system are not answered. However, it is still possible to receive event calls
from the system.
6)
After your code is accepted a system status message is
announced, followed by the Operations menu. You can now
perform the required remote operations, as described in the
subsequent sections.
TIPS:
To repeat the Status message, press
#
.
To bypass further menus and go directly to your required operation, use the
list of quick key combinations on page 31
Operations Menu
The voice operations menu announces options and instructions
to use the system functions. The options in the Operations
menu vary according to system status and your access rights.
For example, to arm the system option is not announced if all
partitions in your system are already armed.
It is not necessary to wait for the end of a message or menu to
enter a selection. If you remember the options listed, you can
press the appropriate key at any time.
Follow the voice prompts to use the system functions.