User manual

WisDom User Manual 29
Chapter 4: Remote Phone System
Operation
The WisDom enables you to operate the system from remote
phone. This consists of initiating a telephone call to or from the
system, and interacting with voice menus that guide you through
your required remote operation.
Remotely Accessing the System
Remotely accessing the system involves initiating a call to the
system, and entering your remote access code and the user
code you usually enter in the system keypad.
All procedures in this chapter are performed by first initiating a
call in this way, and then selecting your required option from the
Operations menu, as described on page 30.
 To remotely access the system:
1)
From a remote touch-tone telephone, dial the number of the
premises where WisDom is installed.
2)
If an answering machine is in use at the premises:
Let the line ring once, then hang up and call again.
NOTE:
Ask your installer to define the Answering Machine Override feature.
In some telephone systems, you may need to wait at least 10 seconds
before calling the system again.
If an answering machine is not in use at the premises:
Wait until the system picks up.
After the system picks up a short tone is heard.
NOTE:
When the system picks up, all phones on the same line are effectively
disconnected, and cannot be used.