User manual

28 WisDom User Manual
To disarm using a duress code:
1)
If outside the premises, open an "entry" door. The
WisDom beeps, indicating that the Entry Delay time
period has begun. The following message will be heard
"System In Disarm Process. Please Enter Your Code"
2)
Enter your duress code and press
.All partitions
assigned to the code are disarmed and a silent alarm is
sent to the Central Station.
Silencing an Alarm
When silencing an alarm the system goes into disarm state.
To silence an alarm:
1)
If outside the premises, open an "entry" door. The
WisDom beeps, indicating that the Entry Delay period has
begun.
2)
Observe the system LEDs. If the ARM LED is flashing and
the display shows the distributed zone, an alarm has
occurred in the system.
3)
Enter your user code and press
. The following
message will be heard:
"System / [Partition X] Disarmed, Alarm Occurred in
the System, Check Display!"
The ARM LED will flash and the display will show the
alarmed zones for the alarm memory period of about 60
seconds. Scroll through the list of alarm zones
NOTES:
It is recommended to leave the premises. Only after police investigation should
you consider that the burglar is no longer in your premises and you can re-
enter.
In special cases (if programmed so during installation), arming the system after
an alarm requires a technician code. On the LCD, a Not ready - Technician
Reset message will appear.