User manual

26 WisDom User Manual
Disarming
Disarming your system causes the detectors not to trigger an
alarm when violated.
The disarming operation will be followed by a local message
announcement (If defined).
NOTE:
If during disarming you enter a wrong user code, the keypad produces three
short beeps and the “Fail to disarm, Wrong Code. Please Try Again” message
will be heard. If so, re-enter the above sequence correctly.
Your WisDom offers the following kinds of disarming:
 System disarming, below
 Partition disarming, page 27
 Duress disarming, page 27
 Silencing an Alarm, page 28
Disarming the System
Disarming deactivates the partitions assigned to the specified
user code.
 To disarm the system:
1)
Enter your user code and press
(All the partitions
assigned to the code will be disarmed).
A confirmation
message will be heard.
NOTE:
If outside the premises, open an "Entry" door. The WisDom beeps,
indicating that the Entry Delay time period has begun. The following
message will be heard:
"System In Disarm Process. Please Enter Your Code"
Before the Entry Delay time period expires, enter your user code and
press .