User manual

WisDom User Manual 23
Stay Arming
Stay arming activates only perimeter detectors (as defined by
your installer), enabling individuals to remain inside and move
about the premises while the system is partially armed.
 To Stay arm:
1)
Check that the system is ready for Stay arming.
2)
Enter your user code and press
. All partitions
assigned to a code will be armed at Stay mode.
NOTE:
If defined by your installer press for quick Stay arming.
3)
If required, leave the premises and close the door. During
the Exit Delay time period, the keypad beeps, the Arm
LED flashes and the Bypass LED lights, indicating the
bypassed interior zones.
NOTE:
Press during the Exit Delay time period to silence the
announcement messages and the beeps from the keypad.
Press twice to cancel the Entry Delay time period. “Entry Delay
Cancelled" message will be heard
4)
When the Exit Delay time period is up, the Arm LED lights
steadily and the following message will be heard:
” System Armed At Stay”.
If the system cannot be armed it will be followed by a “Not
ready to arm” message as described in the Away Arming
section.