User manual

WisDom User Manual 21
Chapter 3: Local Arming and
Disarming of the System
Arming
Arming your system causes the intrusion detectors to trigger an
alarm when violated. The arming operation will be followed by a
local message announcement (If defined).
You can arm your system by code arming, in which you need to
use your user code, or you can use quick arming (without using
a code)
NOTE:
If during code arming you enter a wrong user code, the keypad produces three
short beeps and “Wrong Code. Please Try Again” will be heard. In this case,
press [ ] [ ] quickly and re-enter the sequence correctly.
Before arming your system check the Ready LED. If it is lit or
flashing, the system is READY to be armed. If NOT the system
is NOT ready to be armed. In this case, secure or bypass the
violated zone(s), and then proceed.
Remember, fire protection and the protection offered by the
emergency keys are always armed and always available.
Your WisDom offers the following kinds of arming:
 Away arming, page 22
 Stay (Home) arming, page 23
 Partition arming, page 24