Specifications

Before using this machine, check the following points.

Front and Rear Brake. Check brake action. Check pucks to see that they are not over

worn. There should be visible brake material on both sides of the brake disc. See

Section 6.

Fuel Tank. Check fuel level. Fill as necessary. Use super unleaded for altitudes above

10,000 ft.

Engine Oil. The engine holds .6 qt. of SAE10W30/40 motor oil. Fill to the dipstick “full”

line.

Miter Box and Transmission. They are filled at the factory and need not be checked at

the start. The miter box should have 2.5 oz. of EP 80W90 gear lube oil. The transmis-

sion takes 6 oz. of EP 80W90 gear lube oil. The transmission has a fill to plug near the

bottom of the transmission( shown on page 46). There is no fill level for the miter box.

Over filling of either the miter box or transmission will result in leakage.

Throttle. Check for proper throttle cable operation. Look for smooth response to twist

action.

Wheels and Tires. Check Tire pressure, wear and damage.

Fittings and Fasteners. Check all fittings and fasteners.

Drive Chains. Check chains for tension and lubrication. Adjust tension for 1/2” - 3/4”

deflection at mid point.

Engine Manual. Read your engine manual completely and follow all instructions.

FAILURE TO INSPECT YOUR ROKON BEFORE OPERATION

INCREASES THE POSSIBILITY OF AN ACCIDENT OR EQUIPMENT

DAMAGE. ALWAYS INSPECT YOUR ROKON EACH TIME YOU USE IT

TO MAKE SURE IT IS IN SAFE OPERATING CONDITION.

Section 4 Pre-operation Checks