Owner manual

Light

2. Tounlockthecontrolpanel,pressandholdthe“SystemLock”buttonforthree(3)

seconds. Ensure the System Lock light extinguishes.

Pulsate Mode

This control unit is equipped with the Pulsate Mode. When selected, the control unit

willcontinuouslyreadjustthesystempressure(proportionaltotheComfortLevel

setting).Changeinpressureisgradualtoensuremaximumpatientcomfort.

Toactivate,presseither“High”or“Low”key(fig.38)onthecontrolpanel.The

Pulsate light will illuminate.

The Pulsate Mode adjusts as follows:

Low–20% cycle every 5 minutes

High–20% cycle under one minute

To deactivate the Pulsate Mode, press the Pulsate

OFF button(Fig.39).

Note: You may change the rate of alternating pressure at any time while the

Pulsate Mode is in operation.

Section 13 HybridSelect

Figure 40

SelectAir,

SelectAir Max,

HybridSelect

Models

Flashing

“Green” Light

(Powerto

ControlUnit)

CPR/Emergency Deflate

Important: In case of a CPR Emergency, turn power OFF by pressing the

CPR button on the keypad.

Figure 39

Note: To assist in deflating the mattress, disconnect the hose at the

mattress or control unit.

Figure 38