Specifications

PRODUCTS
Hybrid IC
TYPE
BP35C5
PAGE
31/33
1. LABELING AND USER INFORMATION REQUIREMENTS
The BP35C5 module has been labeled with its own FCC ID number, and if the FCC ID is not visible when the
module is installed inside another device, then the outside of the finished product into which the module is installed
must also display a label referring to the enclosed module. This exterior label can use wording as follows:
A user's manual for the finished product should include the following statement:
Additional information on labeling and user information requirements for Part 15 devices can be found in KDB
Publication 784748 available at the FCC Office of Engineering and Technology(OET) Laboratory Division
Knowledge Database (KDB) https://apps.fcc.gov/oetcf/kdb/index.cfm
2. RF EXPOSURE
All transmitters regulated by FCC must comply with RF exposure requirements. KDB 447498 General RF
Exposure Guidance provides guidance in determining whether proposed or existing transmitting facilities,
operations or devices comply with limits for human exposure to Radio Frequency (RF) fields adopted by the
Federal Communications Commission (FCC).
From the BP35C5 FCC Grant: Output power listed is conducted. This grant is valid only when the module is sold
to OEM integrators and must be installed by the OEM or OEM integrators. This transmitter is restricted for use
with the specific antenna(s) tested in this application for Certification and must not be co-located or operating in
conjunction with any other antenna or transmitters within a host device, except in accordance with FCC
multi-transmitter product procedures.
REV. E
SPECIFICATION No.: TARGET SPECIFICATION
TSZ22111･05･002
This equipment has been tested and found to comply with the limits for a Class B digital device, purs
uant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection again
st harmful interference in a residential installation. This equipment generates uses and can radiate ra
dio frequency energy, and if not installed and used in accordance with the instructions, may cause h
armful interference to radio communications. However, there is no guarantee that interference will n
ot occur in a particular installation. If this equipment does cause harmful interference to radio or te
levision reception, which can be determined by turning the equipment off and on, the user is encoura
ged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Contains Transmitter Module FCC ID: ANSBP35C5
or
Contains FCC ID: ANSBP35C5
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.