Specification Sheet

ManualsBrandsRohl ManualsShower ComponentsRohl Matheson Brass 6-2/3" Pressure Balanced Valve Trim Only with Diverter

MATHESON™ PRESSURE BALANCE BATH OR SHOWER TRIM

WITH INTEGRATED VOLUME CONTROL WITH DIVERTER

ML2015LM

FEATURES

• Metal lever handle

• Pressure balanced concealed bath and shower

mixer trim for R2014D rough valve with volume

and temperature control

• Complete with plate, escutcheon, diverter

and handle

• Components made of solid brass

• Rotate handle clockwise for hot and

counterclockwise for cold

• Move handle up for on, down for off

To complete package order R2014D rough valve

COLORS/FINISHES

• Polished Chrome

• Polished Nickel

• Satin Nickel

WARRANTY

• Limited Lifetime

5 29/32"

6 11/16"

Transitional Matheson™

www.ferguson.com

Consult your local FERGUSON showroom for additional information and speciﬁcations. www.ferguson.com.

Summary of content (5 pages)

PAGE 1
www.ferguson.
PAGE 2
www.ferguson.com INSTALLATION INSTRUCTIONS Installation 1. Remove Mud Please note: package. 3/8” extension 2. Remove trim 3. Install the ca shown. Installing Diverter S 1. Install #18 rub 2. Disassemble 3. Install diverte tighten the #1 Please note: 4. Install diverte Installing Faceplate 1. Install facepla 2. Slide the cove PBV, using th a. b. 1 P.B.V SHOWER DIVERTER VALVE - NOT INCLUDED 2 CARTRIDGE INTERFACE 3 FACEPLATE 3. 4 FACEPLATE NUT Installing lever and 1. Position the b a.
PAGE 3
www.ferguson.com INSTALLATION INSTRUCTIONS h. water and then dry with a a soft cloth and warm ve acid or scouring agent age the surface of the faucet. ex, 409 or Fantastik. ace will not be covered by ROHL MATHESON PBV DIVERTER TRIM SET ML2015LMAPC, ML2015LMPN, ML2015LMSTN For Pressure Balance With Diverter Rough Valve R2014D INSTALLATION INSTRUCTIONS details. (www.rohlhome.com) debris from entering the work on the street Please leave instructions with the home owner once installed. e, CA 92688 home.
PAGE 4
www.ferguson.com INSTALLATION INSTRUCTIONS Installation Instructions 1. Remove Mud cover (not shown) and the #4 faceplate nut on the rough valve. Please note: #4 faceplate nut (R945440) is included with the rough, not the trim package. 3/8” extension kit available; order R945440/2. 2. Remove trim parts #12 through #7 and cartridge interface #2. 3. Install the cartridge interface #2 on cartridge stem and tighten grub screw #19 as shown. Installing Diverter Spindle: 1.
PAGE 5
www.ferguson.com INSTALLATION INSTRUCTIONS Care and Maintenance: After use, wipe down with a soft, dry cloth. For all chrome plated surfaces clean this product with warm soapy water and then dry with a dry soft cloth. Nickel plated, satin and Inca brass finishes should be cleaned with a soft cloth and warm water and then dried with a dry soft cloth.