Specification Sheet

5
www.rohlhome.com
Installation Instructions
Consult your local ROHL showroom for additional information and specifications. For complete warranty details and a list of showrooms, go to www.rohlhome.com.
Check the installation carefully for leaks.
prevent paint, adhesive, etc. from damaging the surface.
If further building work is to be carried out in the vici of the faucet, it should be covered to
- Fix the shower holder (O) placing, before the shaped rubber washer (T) and then the half-moon
and placing the washer between the two parts.
- Repeat this procedure for the cold valve.
Turn on the Hot and Cold supplies to the faucet.
- Ensure all connections are firmly tightened.
- Assemble counterweight (Q) at the nylon flex hose (N).
- Assemble the threaded pivot (S) to the shower holder (O)
- Connect the hot and cold valve body (I) to the two holes cross (B) using the flexible hoses (L)
- Introduce the shower holder (O) in the hole of the deck, placing before the square disc (M) and
- Connect the nylon flex hose (N) to the stainless steel hose (R), placing the washer
- Connect the stainless steel hose (R) to the spout (D) with the hexagonal nut, placing the washer
Maximum temperature for Hot water supply to the faucet is 145° F.
- Connect hot and cold water supplies to side valve inlet.
- Introduce the other end of hose (N) in the shower holder (O).
Minimum recommended pressure is 15 psi - Maximum recommended pressure is 75 psi.
- Connect the hand shower (P) to the nylon flex hose (N), placing the washer between the two
plate (U) and the lengthen nut (V).
parts.
then the O-Ring.
between the two parts.
between the two parts.
c - Before use