Specification Sheet

3 4
www.rohlhome.com
Installation Instructions
Consult your local ROHL showroom for additional information and specifications. For complete warranty details and a list of showrooms, go to www.rohlhome.com.
in the correct position.
A T T E N T I O N
must not be in contact.
be sure that the handle has no play.
Please verify the distance (3/64").
The square disc (H) and the cap (F)
3/64"
Assemble the handle set (G)
screwing the cap (F), placing it
Tighten the trim cap (F) and square disc (H) snugly
so cap (F) is in proper alignment with square disc
(H) on the deck. Tighten hexagonal brass fixing nut
(Z2) under the deck the secure the valve body (I)
into the final assembled position. This final adjustment
may take a few attempts for the installer to achieve
the proper alignment and height of all components
depending on the thickness of the deck.
Mark the side valve between 1 5/8" and 1 3/4"
from the top of the stem with marker.
Screw the upper
X
hexagonal nut (X) making
F
G
end of the body's thread
sure to place it at the
(HEXAGONAL NUT SETUP LINE).
Alternative possible assembling is:
Spin the upper deck nut down to the mark.
Place (H) the square
torque value = 10 lbf.ft.
Maximum fixing nut
A T T E N T I O N
screwing the underside
fixing nut S).
hexagonal brass
position before
disc in the right
Z2
the metal disc (Z1) and
- Assemble the valve body (l) and the handle set (G) following the instructions below :
X
HEXAGONAL NUT
SETUP LINE
H
Place O-Ring (H1) and
H1
square disc (H) on the desk.
hole, first placing
Z1
the washer (Z),
Z
(I) in the deck
brass fixing nut (Z2).
Z2
then the hexagonal
Insert the valve body
I