Brochure

Three simple steps to work with the measurement wizard
CBA
Operator shows the
measurement result to the
project manager/expert and
documents it
Project manager/expert
creates the test sequences
Operator uses the wizard
to execute the test
sequences
Application example of wireless remote operation
via tablet
iOS
Android
6
Single charge lasts the entire work day
With a single full charge, the R&S®Cable Rider ZPH will
keep going an entire work day. Simply charge it for ap-
proximately 4hours and the lithium-ion battery pack lasts
up to 9hours. The advantages of having a long-lasting bat-
tery are obvious – no need to bring an extra battery with
additional weight when climbing up a mast or tower, no
frustration due to the battery power ending in the middle
of the measurement.
Buy what you need when you need it
The base unit supports frequencies from 2MHz to 3GHz
in cable and antenna analyzer mode and 5 kHz to 3GHz in
spectrum analyzer mode. When you need frequencies up
to 4GHz, simply purchase the R&S®ZPH-B4 frequency up-
grade option and enter the keycode into the analyzer. The
supported frequency range is instantly extended to 4GHz.
It is not necessary to send the analyzer to the service lab
for an upgrade or recalibration. No downtime and no need
to buy a new analyzer just for frequency upgrading.
One-step calibration
Typically, calibration is not required if the DUT is
connected directly to the analyzer. However, if there are
additional cables or adapters connected between the
analyzer and the device under test (DUT), calibration is
recommended to eliminate any influences. During cali-
bration, the analyzer calibrates with the open, short and
load standard. For convenient, one-step calibration, the
R&S®ZN-Z103 calibration unit automatically switches inter-
nally between open, short and load. This saves time and
eliminates the hassle of physically changing the different
calibration standards in the field.
Simplify measurements with the wizard function
The measurement wizard simplifies measurements by
automating, standardizing and optimizing test sequences.
A sequence of standardized and recurring measurements
can be performed quickly and easily without mistakes.
The proven wizard function helps eliminate human errors
and helps the user make correct measurements from the
beginning.
Remote control with Android or iOS apps
Not all qualified engineers are qualified climbers. An engi-
neer on the ground might have to give the climber on the
mast or tower instructions for every measurement step.
Remote control of the R&S®Cable Rider ZPH solves this
problem. Simply connect a commercially available wireless
router
1)
to the analyzer and use the apps on the phone or
tablet to remote control the analyzer and fully control the
measurements.
1)
The wireless router is not provided by Rohde & Schwarz.
Efficient