Datasheet

Version 20.00, July 2019
Rohde & Schwarz R&S
®
RTE Oscilloscope 39
R&S
®
RTE-K60
USB 1.0/1.1/2.0/HSIC serial triggering and decoding
Protocol configuration
signal type
single-ended, differential
protocol type
low, full, high speed and HSIC
bit rate
standard bit rates (1.5/12/480 Mbit/s)
source
any input channel
probe type
for low and full speed
single-ended probe
for high speed
differential probe (R&S
®
RT-ZDxx)
for HSIC
single-ended probe(R&S
®
RT-ZSxx)
auto threshold setup
assisted threshold configuration for
USB triggering and decoding
Trigger
trigger event setup
start of packet, end of packet, PID token
(IN, OUT, SETUP, SOF), PID data (Data0,
Data1, Data2
8
, MData
8
), PID handshake
(ACK, NAK, STALL, NYET
8
), PID special
(PRE
9
, ERR
8
, SPLIT
8
, PING
8
); bus state
(reset
9
, resume
9
, suspend
9
); error
condition
address, endpoint and frame setup
SC, port, SEU, ET check (SPLIT)
8
condition =, ≠, ≥, ≤, in range, out of range
data setup
data pattern up to 4 byte (hex, decimal,
octal, binary or ASCII), bit separately
configurable (1, 0 or don’t care);
condition =, ≠; position based or window
based triggering (first occurrence in packet
payload)
error condition
any error, PID error, CRC5 error, CRC16
error, bit stuffing error, unexpected PID,
SE1 error
9
and glitching error
Decode
source
any input channel, math waveform
display type
decoded bus, logical signal, bus + logical
signal, tabulated list
color coding
packet identifier, payload length, frame,
address, endpoint , data payload, CRC5,
CRC16, error condition
data format
hexadecimal, decimal, octal, binary,
ASCII, unsigned
Search
search event setup
combination of start of packet, PID token
(IN, OUT, SETUP, SOF), PID data (Data0,
Data1, Data2
8
, MData
8
), PID handshake
(ACK, NAK, STALL, NYET
8
), PID special
(PRE
9
, ERR
8
, SPLIT
8
, PING
8
); error
condition (any error, PID error, CRC5
error, CRC16 error, bit stuffing error,
unexpected PID, SE1 error
9
and glitching
error)
address, endpoint and frame setup
SC, port, SEU, ET check (SPLIT)
condition =, ≠, ≥, ≤, in range, out of range
data setup
data pattern up to 4 byte (hex, decimal,
octal, binary or ASCII), bit separately
configurable (1, 0 or don’t care);
condition =, ≠; position based or window
based triggering (first occurrence in packet
payload)
error condition
any error, PID error, CRC5 error, CRC16
error, bit stuffing error, unexpected PID,
SE1 error
9
and glitching error
8
Only available in high speed and HSIC.
9
Only available in low and full speed.