Datasheet

Version 20.00, July 2019
32 Rohde & Schwarz R&S
®
RTE Oscilloscope
R&S
®
RTE-K10
SENT serial triggering and decoding
Protocol configuration
signal type
data signal
clock period (clock tick)
1 µs to 100 µs
clock tolerance
0 % to 25 %
data nibbles
1 to 6
serial message type
none, Short Serial Message and
Enhanced Serial Message
CRC version
Legacy (Feb 2008) and v2010 (latest)
CRC calculation
SAE J2716 standard and TLE 4998X
pause pulse
no, yes, for constant frame length
frame length in clock ticks (applicable only
when pause pulse = constant frame
length)
104 to 922
Trigger
source
any analog input channel
trigger event setup
calibration or sync, transmission
sequence, serial message and
error condition
transmission sequence status nibble setup
from 0 to F, condition =, ≠, ≥, ≤, in range,
out of range
transmission sequence data nibbles setup
each nibble value from 0 to F, condition =,
≠, ≥, ≤, in range, out of range
serial message identifier setup
from 00 to FF, condition =, ≠, ≥, ≤, in
range, out of range
serial message identifier type setup
(applicable only when the serial protocol =
Enhanced Serial Message in protocol
configuration)
4 bit and 8 bit
serial message data setup
00 to FF (Short Serial Message),
000 to FFF (Enhanced Serial Message
with 8 bit ID),
0000 to FFFF (Enhanced Serial Message
with 4 bit ID)
error condition setup
form error, calibration pulse error, pulse
period error, CRC error and irregular
frame length error
Decode
source
any analog input channel,
display type
decoded bus, tabulated list
color coding
transmission sequence:
sync/calibration, status, data bits, CRC,
pause pulse (optional), calibration pulse
error, pulse period error, irregular frame
length error and CRC error.
serial message:
identifier, data, CRC, form error, CRC
error
data format
hex, decimal, octal, binary, ASCII
Search
source
any analog input channel
search event setup
calibration or sync, transmission
sequence, serial message and
error condition
event settings
same as trigger event settings