Datasheet

Version 20.00, July 2019
26 Rohde & Schwarz R&S
®
RTE Oscilloscope
LIN serial triggering and decoding
Protocol configuration
version
1.3, 2.x or SAE J602; mixed traffic is
supported
bit rate
standard bit rate (1.2/2.4/4.8/9.6/10.417/
19.2 kbps) or user-defined bit rate in range
from 1 kbps to 20 kbps
device list
associate frame identifier with symbolic ID,
data length and protocol version
auto threshold setup
assisted threshold configuration for LIN
triggering and decoding
Trigger
source
any input channel
trigger event setup
start of frame (sync break), identifier,
identifier + data, wakeup frame, error
condition (any combination of checksum
error, parity error and sync field error)
identifier setup
range from 0d to 63d; select condition =,
≠, ≥, ≤, in range, out of range for trigger
“identifier”; select single identifier and
condition = for trigger “identifier + data”
data setup
data pattern up to 8 byte (hex, decimal,
octal or binary); condition =, ≠, ≥, ≤, in
range, out of range
Decode
source (TX and RX)
any input channel, math waveform,
reference waveform
display type
decoded bus, logical signal, bus + logical
signal, tabulated list
color coding
frame, frame identifier, data payload,
checksum, error condition
data format
hex, decimal, octal, binary, ASCII
Search
search event setup
combination of start of frame (sync break),
identifier, identifier + data, wakeup frame,
error condition (any combination of
checksum error, parity error and sync field
error)
event settings
same as trigger event settings