Datasheet

Version 20.00, July 2019
Rohde & Schwarz R&S
®
RTE Oscilloscope 23
R&S
®
RTE-B10
Additional GPIB interface
Function
interface in line with IEC 625-2
(IEEE 488.2)
Command set
SCPI 1999.0
Connector
24-pin Amphenol female
Interface functions
SH1, AH1, T6, L4, SR1, RL1, PP1, DC1,
DT1, C0
R&S
®
RTE-B18
Additional removable solid state disk
Disk type
solid state disk
Disk size
nom. ≥ 240 Gbyte
Firmware
installed upon delivery
R&S
®
RTE-K1
I
2
C serial triggering and decoding
Protocol configuration
bit rate
up to 3.4 Mbps (auto-detected)
auto threshold setup
assisted threshold configuration for I
2
C
triggering and decoding
device list
associate frame address with symbolic ID
Trigger
source (clock and data)
any input channel or logical channel
trigger event setup
start, stop, restart, missing ACK, address,
data, address + data
address setup
7 bit or 10 bit address (value in hex,
decimal, octal or binary); ACK, NACK or
either; read, write or either; R/W bit
included in address value or apart;
condition =, ≠, ≥, ≤, in range, out of range
data setup
data pattern up to 8 byte (hex, decimal,
octal or binary); condition =, ≠; ≥, ≤, in
range, out of range; offset within frame in
range from 0 byte to 4095 byte
Decode
source (clock and data)
any input channel, math waveform,
reference waveform, logical channel
display type
decoded bus, logical signal, bus + logical
signal, tabulated list, decode layers
color coding
frame, start/restart, address, R/W bit, data,
ACK/NACK, stop, error
address and data format
hex, decimal, octal, binary, ASCII;
symbolic names for user-defined subset of
addresses
decode layer
off, edges, bits
Search
search event setup
combination of start, stop, restart, missing
ACK, address, data, address + data
event settings
same as trigger event settings