Datasheet

Version 20.00, July 2019
Rohde & Schwarz R&S
®
RTE Oscilloscope 19
Pattern
triggers when the source goes true or stays true for a period of time shorter, longer,
equal, inside or outside a specified range
sources
any logical combination of D0 to D15 or
any user-defined bus signal
pulse width
200 ps to 10 s
State
triggers on the slope (positive, negative or either) of the clock signal when data signal
matches a user-defined logical state
data signal
any logical combination of D0 to D15 or
any user-defined bus signal
clock signal
any channel from D0 to D15
Serial pattern
triggers on a serial data pattern of up to 32 bit; pattern bits may be high (H), low (L) or
don’t care (X); clock edge slope may be positive, negative or either
data signal
any channel from D0 to D15 or any logical
combination of D0 to D15
clock signal
any channel from D0 to D15 or any analog
channel
max. data rate
1.00 Gbps
optional
see dedicated triggering and decoding
options
sources
any channel from D0 to D15
Waveform measurements
General features
measurement panels, gate, statistics,
long-term analysis and limit check; see
features of the base unit
Measurement sources
all channels from D0 to D15 or any logical
combination of D0 to D15
Automatic measurements
positive pulse width, negative pulse width,
period, frequency, burst width, delay,
phase, positive duty cycle, negative duty
cycle, positive pulse count, negative pulse
count, rising edge count, falling edge
count
Additional cursor function
display of decoded bus value at the cursor
position
Waveform math
Function
any logical combination of D0 to D15
Search and mark functions
The search function will be available in a future software release.
Display characteristics
Display of logical channels
selectable size and position on screen,
diagram configuration by dragging and
dropping signal icons
Bus decode
number of bus signals
4
bus types
unclocked and clocked
display types
decoded bus, logical signal, bus + logical
signal, amplitude signal, amplitude +
logical signal, tabulated list (decoded time
interval selected with cursors)
position and size
size and position on screen selectable
data format of decoded bus
hex, unsigned integer, signed integer,
fractional, binary
data format of amplitude signal
unsigned integer, signed integer,
fractional, binary offset
Channel activity display
independent of the oscilloscope
acquisition, the state (stays low, stays high
or toggles) of the channels from D0 to D15
is displayed in the signal icon