Brochure

Active single-ended probe
Upgrade to an active single-ended
probe for more accurate higher
frequency measurements.
An amplifier built into the probe
near the tip ensures low capacitive
loading.
Benefits
► Low capacitive loading minimizes
loading influence at higher
frequencies
► Integrated R&S®ProbeMeter
provides DC level with very high
accuracy
► Built-in offset compensation
enables higher vertical sensitivity
Power rail
Active single-ended
Active differential
Current
High voltage
Probe type
Active differential probe
Use differential probes
to measure single-ended
signals (signal to ground)
and differential signals (plus
versus minus).
Benefits
► Confidently capture differential
signals
► High common mode rejection
ratio ensures accuracy with large
common mode changes
► Signals under test retains high
fidelity with thanks to capacitive
probe loading
Current probe
Choose a clamp-on current probe
for non-intrusive current measure-
ments. These probes have a neg-
ligible effect on the device under
test and come in models with vary-
ing current and bandwidth ratings.
Benefits
► Quickly measure small to large
currents without disturbing your
device
► Measure low to high frequency
(>100MHz) current bandwidth
► Easily connect and power the
probe with the Rohde & Schwarz
probe interface on the
oscilloscope
Power rail probe
Use a power rail probe to
measure small AC charac-
teristics of DC signals. These
probes have a large built-in
offset, 1:1 low-noise attenua-
tion and excellent DC loading.
Benefits
► Accurately measure your power
rail with a low-noise 1:1 probe
attenuation factor
► High offset enables use of small
vertical settings
► Integrated R&S®ProbeMeter
accurately measures the
DCvoltage
High voltage probe
Safety is a key consideration
when measuring high
voltages. High voltage
differential probes with the
appropriate CAT rating make
sure that large voltage spikes
cannot harm the operator.
Benefits
► Measure fast-switching
semiconductors up to 200 MHz
► Large offset compensation
range up to 2000 V enables
higher resolution
► High common mode rejection
ratio enables accurate gate-
source voltage measurements
CHOOSE THE RIGHT PROBE
FOR YOUR APPLICATION
https://www.rohde-schwarz.com/
product/power_rail_probes
https://www.rohde-schwarz.com/
product/high-voltage-probes
https://www.rohde-schwarz.com/
product/active_single-ended_probes
https://www.rohde-schwarz.com/
product/active_differential_probes
https://www.rohde-schwarz.com/
current_probes